site logo

What do I need to pay attention to in the storage and preservation of 316L stainless steel angle?

Time:2022-03-28 Source:Wuxi Jianuo Special Steel Co., Ltd.

What do I need to pay attention to in the storage and preservation of 316L stainless steel angle?

In the custody and storage of 316L stainless steel angle carry out the link, must ensure waterproof and moisture-proof, in order to prevent 316L stainless steel angle rust and corrosion and thus cause product quality reduction, in addition to 316L stainless steel angle custody storage also have some other common problems, need to further follow the excellent first put, effective stacking standards. Dongzheng stainless steel plate for you to summarize the following aspects.

1648458926(1)

1) The basic principle of stacking is to ensure that under the standard of solid stacking and safety, the stacking is made according to the type and specification, and the materials of different categories should be stacked separately to avoid mixing and leaching each other.

2) Prohibit the storage of stainless steel sheet around the pile with leaching function.

3) The bottom of the pile should be raised, firm and level, to avoid the return of moisture or deformation of raw materials.

4)The same material is stacked according to the respective order of entry into the warehouse, which is conducive to the implementation of the standard of excellence first.

5) For the channel steel stacked outdoors, the lower side must have wooden mats or stone strips, and the surface of the stack should be slightly skewed to facilitate drainage pipes, and pay attention to the vertical placement of raw materials to avoid bending and deformation.

6) The palletizing height to width ratio should not exceed 1.2m for human operation, 1.5m for mechanical equipment, and 2.5m for palletizing width.

7) A certain safety channel should be left in the middle of the pallets and stacks, and the inspection channel is generally 0.5m, and the safety channel is generally 1.5-2.0m depending on the size of raw materials and conveying machinery.

8) The bottom of the stack should be padded, if the warehouse is concrete ground in Chaoyang District, it can be raised by 0.1m; if it is a mud road, it must be raised by 0.2-0.5m. If it is an outdoor place, the concrete ground should be raised by 0.3-0.5m, and the sand and mud surface should be raised by 0.5-0.7m.

9) Outdoor stacking angle iron and steel pipe should be placed on the top, that is, the mouth facing down, the work section steel should be placed upright, the I-slot surface of stainless steel plate can not face upward to prevent water storage rust.